Текущий статус : Отозвано

Это стандарт пересмотренISO 18278-1:2015

Тезис

ISO 18278-1:2004 recommends procedures for determining the generic weldability for resistance spot, seam and projection welding of metallic materials.

This procedure is applicable for the assessment of the weldability of uncoated/coated steels, stainless steels and non-ferrous alloys such as aluminium, titanium, magnesium and nickel and their alloys of single thickness lower than or equal to 5 mm.

The weldability of metallic materials in resistance welding is defined in terms of:

  • the ability to make the weld in the first place;
  • the ability to continue making welds;
  • the ability of the weld to withstand the imposed service stresses.

The procedures recommended in ISO 18278-1:2004 can be used to:

  • compare the weldability of different metallic materials;
  • compare the welding response of particular welding equipment and allow comparisons between different equipment and determine the influence of the static/dynamic properties of different welding equipment;
  • determine the weldability of a material when any welding configuration is changed e.g. electrode material and/or shape, water cooling requirements etc.;
  • investigate the effect of welding parameters such as welding current, weld time, electrode force or complex welding schedules including pulse welding, current stepping etc. on weldability.

Общая информация

  • Текущий статус
     : Отозвано
    Дата публикации
     : 2004-11
    Этап
    : Отмена международного стандарта [95.99]
  • Версия
     : 1
  • Технический комитет :
    ISO/TC 44/SC 6
    ICS :
    25.160.01 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Интернет-магазин
  3. Каталог стандартов
  4. ТК
  5. ISO/TC 44/SC 6
  6. ISO 18278-1:2004