ISO/TS 11155-1:2001

Estado : Publicado (En proceso de revisión)

Esta norma se revisó y confirmó por última vez en 2024. Por lo tanto, esta versión es la actual.

	Formato	Idioma
std 1 173	PDF
std 2 173	Papel

Convertir Franco suizo (CHF) a tu moneda

Resumen

This part of ISO/TS 11155 specifies a particulate filtration test, including the critical characteristics of equipment,

test procedure and report format, for the consistent assessment of filter elements in a laboratory test rig with

particle sizes larger than 0,3 μm. It is applicable to filters for removing particulate matter from external or

recirculated air used for ventilating motor vehicle passenger compartments or cabins.

The test specified in this part of ISO/TS 11155 enables an assessment of filter elements for pressure loss,

fractional filtration efficiency and accelerated particulate holding capability against standardized laboratory

particulate challenges. Because the test methods exclude the full range of possible particulate challenges and

environmental effects, the relative ranking of filters may change in service.

NOTE 1 Absolute comparability is only possible with filter elements of the same shape and size as well as the same position

in the test duct.

NOTE 2 Subject to agreement between supplier and the customer, the test procedure allows for the calculation of

gravimetric efficiency as a single parameter for quality control purposes. For gravimetric efficiency tests refer to ISO 5011.

Previsualice esta norma en nuestra Plataforma de navegación en línea (OBP)

Esta norma contribuye al siguiente Objetivo de Desarrollo Sostenible

Check out our FAQs

Customer care

+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)